![cannon gun safe battery replacement cannon gun safe battery replacement](https://i.ytimg.com/vi/C8EWWiQkjCU/maxresdefault.jpg)
Since my chosen drill point was very close to the bottom hole, I tapped the left and right screw holes and fastened my Helix drill template using those holes instead. Note that the safe had four screw holes for keypad mounting but that only the top and bottom ones were tapped. This means the solenoid is horizontally oriented, with its centerline about 11/16” below the center of the cable hole. Based on this, I knew that the lock was mounted in the standard position with the lockbolt pointing downward. I could also see that the cable inside the safe was routed leftward from the cable hole. Within the lock, this little hole is located where a typical mechanical safe lock would have its dial spindle. Looking through the safe's cable hole, I could see a 1/8” hole in the lock case. To determine the location of the solenoid, it was necessary to ascertain the orientation of the lock itself. I decided to drill for the lock's solenoid. Some people are better at electronic diagnostics than I am.) (I'm not entirely satisfied that there was no way to make this lock work. I concluded that the logic in the lock's electronics was, for some reason, not functioning properly.Ĭonsidering this problem to be beyond my ability to correct while the safe is locked, I moved on to opening the safe through frontal penetration. I used the code, but the lock did not give the confirmation beeps that I expected to hear afterward.
#CANNON GUN SAFE BATTERY REPLACEMENT CODE#
I connected a new keypad with a new Duracell alkaline battery and tried again, but the outcome was no different.Ĭannon had given me the management reset code that should reset the lock's combination to 123456#.
![cannon gun safe battery replacement cannon gun safe battery replacement](https://i.ytimg.com/vi/ELup0tjMXDk/maxresdefault.jpg)
![cannon gun safe battery replacement cannon gun safe battery replacement](https://safeandcosy.com/wp-content/uploads/2019/04/winchester_lg_3.jpg)
I rotated the three-spoke handle in the closing direction (clockwise) to ensure that the bolt carriage was not in contact with the lockbolt, then tried the combination again. This is known to happen when the boltwork is resting against the lockbolt. The keypad responded to each button press by beeping as usual, but when the proper combination was entered, the solenoid did not click. My job on the first of these Executive Vaults was to open it and replace the malfunctioning Sargent & Greenleaf Z02 RotaryBolt lock. These “vaults” are gun safes by Cannon Safe, Inc. One day I had the privilege of working on two safes by the same name– Executive Vault. I've done a lot of work on gun safes lately.